Tighter Tolerances on Machined Housing can be held if necessary. Call Us or Ask an Engineer
Standard tolerances on tooled bodies are as follows:
Length = ±.005”
Width = ± .005”
Wall thickness = ±.005”
Bottom thickness = ± .002”
See Standard Tolerance data sheet for additional information.
Standard tolerance on leads dimensions are as follows:
Flatpack external lead length = MIN (from ext wall of case to near edge of tie bar)
Flatpack internal lead length = +.010”/-.005” or ±.007”
Plug-in external lead length (“chop”) = ±.010”
Plug-in internal lead length (“post height”) = ±.005”
Rectangular lead width = ±.003”
Rectangular lead thickness = ±.002”.
Round pin diameter =±.002”.
See Standard Tolerance data sheet for additional information.
Seals
Standard glass meniscus is .010 max.